Archive for the ‘video’ Category

TurboFoam General Operation

Tuesday, June 30th, 2015

The TurboFoam is a direct injection foam proportioning system that is available in several models with a variety of features. This video provides basic instructions on operating the TFC200, TFC300, and TFC400 models.

This video is not a replacement for the system manual.
Please consult the manual for more details.

Setting the time on InControl Governors

Wednesday, November 26th, 2014

This video describes the procedure for setting the time on the FRC InControl TGA300 or TGA400 series governors. Remember, when setting the time the governor must be powered on and the water pump cannot be engaged.

Setting the date can be accomplished in a similar fashion.
Please consult the manual (page 22) for more details.

Checking the firmware revision on InControl Governors

Wednesday, October 29th, 2014

We all know that it’s a good idea to have a serial number handy before calling for technical support. In the case of an electronic pressure governor it may also be useful to know what version of software the governor is running. If an important update becomes available an OEM or dealer may update the software after shipment. Your governor may not be running the same version of software that shipped with it!

It’s simple to check the firmware version (called the “software program revision number” in the manual or “program revision code” in this video) on an FRC InControl TGA300 or TGA400 series governor. This video describes the procedure.

How to update the firmware in FRC Governors

Monday, August 11th, 2014

This video describes the procedure for updating the firmware in your FRC PumpBoss, InControl, or ThrottleXcel governor. Firmware is the onboard software that makes your device function the way that it does. If there is an update to this software that offers new features, or fixes bugs discovered since release, you can follow this method to update it. Firmware should be obtained only from an authorized FRC service representative.

Insight Ultimate Calibration

Monday, December 16th, 2013

A commonly asked question for our service staff is how to calibrate the Insight Ultimate Flow and Pressure Meter. Calibration of the meter is simple, and is described well in the manual (page 26), but sometimes it helps to actually see how things are done! There is a video available for each of the techniques.

Single Point Calibration
Calibrates the device at the most common flow rate. This is the simplest procedure and should serve well in most cases.

Multi Point Calibration
Calibrates the device at several flow rates. This can help improve accuracy when the flow sensor is installed in a difficult plumbing location.